|
Eliminate
the need for left or right shut offs
|
     |
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
Whatever you wish to spread, a KRM Trend Spreader will produce the most accurate spread pattern possible, using the double, double overlap principle, simply leaving the adjustment of one lever for rate. The very wide, shallow tapering pattern with huge overlap means that different materials, cross winds or driver error have little effect on the overall accuracy. This is achieved without changes of discs, vane position or feed point, giving KRM spreaders a flexible and tolerant system which is accurate, consistent, easy to set . . with much less risk of striping. This double, double overlap system also means that when leaving or approaching a headland at 90 degrees or at differing angles, it is only necessary to switch on or off the full spread . . . eliminating the risk of error from complex left and right shut off controls. View the video to see for yourself! The video was produced using actual test result data from an "In Spinning" KRM Trend spreader and compared with results from an "Out Spinning" spreader. The simulation depicts two identical fields, the left field being spread with the KRM "In Spinning" system and the right field with the "Out Spinning" method. Each field is spread in the same sequence, starting first with the headland, then working across the field. The single shut-off point for the KRM system and the separate left and right shut-offs for the "Out Spinning" method are indicated as the field area is covered. The start (shown green) and shut-off (shown red) points for each system are optimised to give the "best" result in each case. The resulting comparison demonstrates that there is absolutely no difference in overall spreading accuracy between the simple to operate KRM "In Spinning" (or In-Centre) system and the more complex "Out Spinning" (or Off-Centre) system. And using the KRM system could not be more simple . . . only half the start and shut-off points are needed, making precise spreading much easier for the operator. KRM Trend spreaders,
for top precision with practical on-farm tolerance, easy to set
and easy to use ! |
||
 |
||
